Sony SupportHT-AN7 / BRAVIA Theatre U

Article ID : 00269890 / Last Modified : 19/05/2024Print

The spatial sound (3D surround sound) initial setup screen is not displayed on the BRAVIA XR TV.

    IMPORTANT: This article applies only to specific products. Check the Applicable Products and Categories section of this article. You can see a list of the applicable TV models on the https://www.sony.net/bravia-xr-series?sqr page.

    If the settings screen for the 3D surround function is not displayed on the TV, check the following:

    1. Reset the TV.
    2. Make sure to update the TV software to the latest version.
    3. Make sure the transmitter and TV are connected with both an optical cable and a USB cable.
    4. Make sure the Bluetooth setting on the TV is set to On:
      Note: The TV must detect the transmitter by Bluetooth in order to perform the set up.
      1. On the remote control, press the Quick settings button.
      2. Select Settings.
      3. Select Remotes and Accessories.
      4. Select Bluetooth, then set to On.
    5. Adjust the distance and position of the transmitter and TV.
      Note: If there are any devices near the TV which emit radio signals, turn them off or move them away from the TV.

    Note: To set the initial 3D surround settings later, follow the steps below.

    1. On the TV remote control, press the Quick Settings button.
    2. Select Settings.
    3. Select Remotes & Accessories → 3D surround Neckband Speaker/Headphones → Set up 3D surround.
    4. Follow the on the screen instructions.